Din Rear-Mount; Removing The Unit - Pioneer DEH-2250UBG Manual De Instrucciones

Section
03 Installation

DIN Rear-mount

1 Determine the appropriate position
where the holes on the bracket and the
side of the unit match.
2 Tighten two screws on each side.
Truss screw (5 mm × 8 mm)
Mounting bracket

Removing the unit

1 Extend top and bottom of the trim ring
outwards to remove the trim ring. (When
reattaching the trim ring, point the side
with the groove down.)
! Releasing the front panel allows easier ac-
cess to the trim ring.
2 Insert the supplied extraction keys into
both sides of the unit until they click into
place.
16
En
Dashboard or console
Trim ring
3 Pull the unit out of the dashboard.