Stanley FMFP12704 Manual De Operación Y De Mantenimiento página 5

• Be aware that when the tool is being utilized
at pressures on the high end of its operating
range, nails can be driven completely through
thin or very soft work material. Make sure the
pressure in the compressor is set so that nails
are set into the material and not pushed com-
pletely through. (Fig. P)
• Keep hands and body parts clear of immediate
work area. Hold workpiece with clamps when
necessary to keep hands and body out of potential
harm. Be sure the workpiece is properly secured
before pressing the nailer against the material. The
contact trip may cause the work material to shift
unexpectedly. (Fig. Q)
• Do not use tool in the presence of flammable
dust, gases or fumes. The tool produces sparks
that could ignite causing a fire. Driving a nail into
another nail may also cause a spark. (Fig. R)
• Keep face and body parts away from back
of the tool cap when working in restricted
areas. Sudden recoil can result in impact to the
body, especially when nailing into hard or dense
material. (Fig. S)
• Grip tool firmly to maintain control while
allowing tool to recoil away from work surface
as fastener is driven. In bump action mode
(contact actuation
is allowed to recontact work surface before
trigger is released an unwanted fastener will be
driven.
BUMP OR CONTACT ACTUATION TRIGGER
• When using the bump action trigger, be careful
of unintentional double fires resulting from
tool recoil. Unwanted fasteners may be driven
if the contact trip is allowed to accidentally
re-contact the work surface, while the trigger
is still being held in the actuated position.
(Fig. T)
TO AVOID DOUBLE FIRES:
• Do not engage the tool against the work surface
with a strong force.
• Allow the tool to recoil fully after each actuation
and release trigger after actuation.
• When bump actuating the nailer, always keep
tool in control. Inaccurate placement of tool
can result in misdirected discharge of a
fastener possibly causing injury.
mode) if contact
5 - ENG
Fig. P
Fig. Q
Fig. R
Fig. S
trip
Fig. T
FIG. U