Important Safety Instructions For Pneumatic Tools; Definitions - Safety Guidelines - Stanley FMFP12704 Manual De Operación Y De Mantenimiento

IMPORTANT SAFETY INSTRUCTIONS
When using any pneumatic tool, all safety precautions, as outlined
below, should be followed to avoid the risk of death or serious injury. Read and
understand all instructions before operating the tool.
The definitions below describe the level of severity for each signal word. Please read
the manual and pay attention to these symbols.
Indicates an imminently hazardous situation which, if not avoided,
will result in death or serious injury.
Indicates a potentially hazardous situation which, if not avoided,
could result in death or serious injury.
Indicates a potentially haz ard ous situation which, if not avoided,
may result in minor or moderate injury.
Used without the safety alert symbol indicates a situation which, if not
avoided, may result in property damage.
• Actuating tool may result in flying debris,
collation material, or dust which could harm
operator's eyes. Operator and others in work
area MUST wear safety glasses with side
shields. These safety glasses must conform to ANSI
Z87.1 (CAN/CSA Z94.3) requirements (approved
glases have "Z87" printed or stamped on them). It is
the employer's responsibility to enforce the use of eye
protection equipment by the tool operator and other
people in the work area. (Fig. A)
• To minimize flying dust and debris rotate exhaust
deflector away from you and others in the work
area.
• Always wear appropriate personal hearing
and other protection during use. Under some
conditions and duration of use, noise from this
product may contribute to hearing loss. (Fig. A)
• Use only clean, dry, regulated air. Condensation
from an air compressor can rust and damage the
internal workings of the tool. (Fig. B)
• Regulate air
compatible with ratings on the nameplate of the
tool. [Not to exceed 120 psi (8.3 bar).] Do not connect
the tool to a compressor rated at over 175 psi. The tool
operating pressure must never exceed 175 psi even in
the event of regulator failure. (Fig. C)
FOR PNEUMATIC TOOLS
SAVE THESE INSTRUCTIONS

DEFINITIONS - SAFETY GUIDELINES

pressure. Use air pressure
2 - ENG
Fig. A
Fig. B
Fig. C
70 psi
4.9 bar
Fig. D