Daily Use - Drying Only; Timed Drying; Daily Use - Washing & Drying - Zanussi ZWT 71401 WA Manual De Instrucciones

DAILY USE - DRYING ONLY

WARNING! Refer to Safety chapters.
DRYING SETTING
The recommended load size is 4 kg for
cottons and linen, and 2 kg for
synthetic items.
1. Load the laundry one item at a time.
2. Turn the programme dial to the programme
applicable for the items to dry (cottons or
synthetics).
To have a good drying performance
do not exceed the maximum drying
loads recommended in the user
manual. Do not set a spin speed
lower than the automatic speed of the
set programme.

TIMED DRYING

1. Press the button Tiempo/Tempo de sec. again
and again to set the time value (see the
«Programmes for timed drying» table).
• Each time you press this button the time
value increases by 5 minutes.
• As the appliance calculates also the
duration of the anti-crease and the cooling
phases, the programme time will
automatically increase by some minutes.
2. Press Inicio/Pausa button to start the
programme.
• The display shows regularly a new time
value.
DAILY USE - WASHING & DRYING
WARNING! Refer to Safety chapters.
NON-STOP PROGRAMME (AUTOMATIC
WASHING & DRYING)
For NON-STOP programme the recommended
load size is 4 kg for cotton and 2 kg for synthetic.
CAUTION! Do not use a dosing
device/ball when carrying out a
washing and drying programme.
1. Load the laundry one item at a time.
14
• The indicator Puerta/Porta is on.
If you set only 10 minutes of drying,
the appliance performs only a cooling
phase.
If the laundry is not sufficient dry, set again a short
drying time.
END OF THE DRYING PROGRAMME
The appliance stops automatically.
• The acoustic signals operate (if they are active).
• In the display comes on.
• The indicator of the Inicio/Pausa button goes
off.
• The last minutes of the drying cycle the
appliance performs a cooling and anti-crease
phase. The door is still locked. The display show
a flashing .
When the door locked indicator Puerta/Porta goes
off, you can open the door.
1. Turn the programme knob to
deactivate the appliance.
After some minutes from the end of the programme,
the energy saving function automatically
deactivates the appliance.
2. Remove the laundry from the appliance.
Make sure that the drum is empty.
3. Keep the door ajar, to prevent mildew and
odours.
4. Close the water tap.
2. Put the detergent and the additives in the
appropriate compartment.
3. Turn the programme knob to the required
programme to switch the machine on.
4. Set the available options.
To have a good drying performance
do not exceed the maximum drying
loads recommended in the user
manual. Do not set a spin speed
lower than the automatic speed of the
set programme.
position to