Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Important!
• The selected delay can be changed only after selecting
the washing programme again.
• The door will be locked throughout the delay time. If
you need to open the door, you must first set the wash-
ing machine to PAUSE by pressing button 7 and wait a
few minutes before opening the door. After you have
closed the door, press the same button again.
Important! The Delay Start cannot be selected with the
draining programme.
Altering an option or a running programme
It is possible to change some options before the pro-
gramme carries them out.
Before you make any change, you must pause the washing
machine by pressing button 7.
Changing a running programme is possible only by reset-
ting it. Turn the programme selector dial to
to the new programme position. Start the new programme
by pressing button 7 again.
The washing water in the tub will be not emptied out.
Interrupting a programme
Press the button 7 to interrupt a programme which is run-
ning, the corresponding pilot light starts blinking. Press
the button again to restart the programme.
Cancelling a programme
Turn the selector dial to
is running. Now you can select a new programme.
Opening the door after the programme has started
First set the machine to pause by pressing the button 7.
If the pilot light 9 goes off, the door can be opened.
Stand by : once the programme has finished after a few
minutes the energy saving system will be enabled. The
brightness of the display is reduced. By pressing any but-

Use - Drying

Drying only
Caution!
The recommended load size is 4 kg for cottons and linen
and 3 kg for synthetic items.
www.zanussi.com
All manuals and user guides at all-guides.com
and then
to cancel a programme which
If the pilot light 9 remains lit, this means that the machine
is already heating or that the water level is too high. In any
case, do not force the door!
If you cannot open the door but you need to open it,
switch the machine off by turning the selector dial to
After a few minutes the door can be opened.
(Pay attention to the water level and temperature!).
After closing the door, it is necessary to select the pro-
gramme and options again and to press button 7.
At the end of the programme
The machine stops automatically. The blinking
on the display, the pilot light of button 7 and the pilot light
9 go off.
If a programme or an option that ends with water left in the
tub has been selected, the pilot light 9 remains on and the
door is locked to indicate that the water must be emptied
out before opening the door.
Before you empty out the water, the drum continues to run
at regular intervals until the water draining.
Follow the below instructions to empty out the water:
1.
Turn the programme selector dial to
2.
Select the draining or spinning programme.
3.
Reduce the spin speed if needed, by pressing the
relevant button.
4.
Press button 7.
At the end of the programme, the door is released and can
be opened. Turn the programme selector dial to
switch the machine off.
Remove the laundry from the drum and carefully check
that the drum is empty. If you do not intend to carry out
another wash, close the water tap. Leave the door open to
prevent the formation of mildew and unpleasant smells.
ton the appliance will come out of the energy saving sta-
tus.
By pressing Drying Time button it is also possible
to dry up to 6 kg of cotton items (see the «Drying
Programme » table).
Caution!
The water tap must be open and the drain hose must be
positioned in the sink or connected to the drain pipe.
1.
Load the laundry.
.
appears
.
to
15

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido