Fiamma CARRY-BIKE UL 48 Instruciones De Montaje Y Uso página 13

Portabicicletas
Ocultar thumbs Ver también para CARRY-BIKE UL 48:
Tabla de contenido

Publicidad

DE
Gebrauchsanweisungen und Ratschläge
FR
Instructions et conseils
IT
Avvertenze e suggerimenti
- The Carry-Bike UL 48 is an universal bicycle carrier for motorhomes with flat rear walls.
It is supplied with the Bike-Block blocking system and two Quick Rails. It is delivered as
standard for transporting 2 bicycles. Do not to exceed the max. weight of 35 kg.
- If you exceed the maximum permitted weight, the braking distance of your vehicle will be
increased. Check before you leave.
- Setting the Carry-Bike on rear axis of the vehicle, the standard weight distribution on two
axis could be modified; be sure that it doesn't exceed the maximum permitted load (verify
the data on your own logbook).
- Never exceed the maximum permitted length and the total weight of the full-load vehicle.
- Do not cover the number plate or lights. Repeat lights and plate by using a trailer board if
the Carry-Bike covers them, even partially.
- Before installation, clean carefully the area where the bicycle rack will be mounted and
use rubber protectors in order to avoid any friction, and consequently, any damages to
the body/paint of the vehicle. Periodically check rubber parts and, in case they are porous
or worn, immediately replace them. If not used for long periods, we suggest to remove
the Carry-Bike from the vehicle.
- Make sure that the support brackets are located where they cannot move or shift
sideways. They also must not touch the roof of the vehicle, the hinges and the
corresponding bolts or screws.
- Periodically check the bicycle rack to make sure it is firmly attached, especially during the
first 10 km. Make sure the belts are not loose and that the holding brackets have not
shifted.
- In case you use the bike cover, pay attention that it is duly fixed and does not cover the
lights. Detachable parts like child safety seats, bags or air compressor have to be
uncoupled and put away inside the vehicle.
- Bicycles have to be fixed both with two Quick-Safe (one piece per wheel) and Security
Strip on the frame. Both Quick-Safe and Security Strip have to be periodically checked.
In case of damage, they have to be immediately replaced.
- For extra safety travelling, we suggest using steel cable antitheft device.
- While fixing the bikes, verify that there is enough distance between handlebars and/or
pedals and vehicle's wall, to avoid compromising the paintwork.
- The load must be evenly distributed (the heaviest bike must be placed near the wall of the
vehicle).
- Be careful when driving and beware of hairpin bends and of gusts of wind. Also keep in
mind that you need a longer braking distance. Beware dangerous road crossing and
garage's entrance. Additional rear view mirrors are required in case of reduced visibility.
EN
Maintenance instructions
ES
Recomendaciones
Carry-Bike
13

Publicidad

Tabla de contenido
loading

Tabla de contenido