Tabla de contenido
Publicidad
7-6-4
Replacing the Solenoid
1.
Remove the gun cover and gun slide (R).
7-6-3 page 65)
2.
Disconnect the solenoid connector.
3.
Remove 1off cap screw (M3x10) on the gun cover (L) and remove the
solenoid bracket.
4.
Remove 1off cup screw M (M3x8) and detach the earth wire.
5.
Loosen the nuts (16mm dia.) and remove the solenoid.
6.
Remove 2off cup screws M (M4x6) and detach the slide guide.
7.
Pull out the solenoid plunger, taking care not to lose the spring.
8.
Reassemble in reverse order.
Note: When reassembling match the D-type hole of the solenoid
bracket to the D shape of the solenoid and ensure that the 'E' ring
and spacers are in the correct positions.
Page 66
(See 7-6-2 page 64
and
Publicidad
Tabla de contenido
