Initialization - NAMCO 500 GP Dlxe Manual Del Operador

7. INITIALIZATION

Adjustments when Replacing Parts
The following operation must always be performed after replacing the Game PCB,
Rom, or Control Potentiometers.
The game will not operate correctly if these adjustments are not made.
1. Slide the TEST switch ON while pressing and holding the SERVICE switch. The
following screen is displayed.
2. Ensure that the motorcycle is in the upright central position and press the View
Change Button.
3. Lean the motorcycle fully to the right and press the View Change Button.
4. Lean the motorcycle fully to the left and press the View Change Button.
5. Ensure that the throttle is fully released and press the View Change Button.
6. Twist the throttle fully on and press the View Change Button.
7. Ensure that the brake lever is fully released and press the View Change Button.
8. Pull the brake lever fully on and press the View Change Button.
9. The following screen will be displayed.
I/F INITIALIZE
Controlling device initializing
Set the motorcycle to center and
press view change button
BANK CENTER
BANK RIGHT
BANK LEFT
GAS OFF
GAS FULL
BRAKE OFF
BRAKE FULL
Page 50
0000
0000
0000
0000
0000
0000
0000