Handle Bar Assembly; Replacing The Throttle Control Pot; Replacing The Brake Control Pot - NAMCO 500 GP Dlxe Manual Del Operador

8-2

Handle Bar Assembly

Remove 4off security screws (M4x12), and remove the handle bar assembly cover to
gain access to the throttle and brake controls.
NOTE:- The game must be re-initialized whenever the PCB, ROMS, Throttle, Brake or
Steering controls are replaced.
8-2-1

Replacing the Throttle Control Pot

1) Slacken the grub screw
M3x5 securing the
control pot shaft to the
drive gear, and remove
the gear.
2) Replace the control pot
ensuring that the the pot
is replaced in the same
position, and the wires
are replaced to the
correct terminals.
3) Turn the control pot
shaft until the flat is
vertical and to the right,
when looking at the
shaft. Replace the drive
gear ensuring that the
control pot shaft does
not turn and the grub
screw in the drive gear
is on the flat of the shaft
4) Re-tighten the grub
screw M3x5
8-2-2 Replacing the Brake
Control Pot
1) Slacken the grub screw
M3x 5 securing the
control pot shaft to the
brake assembly.
2) Replace the control pot
ensuring that the pot is
fitted in the same
position, and the wires are replaced to the correct terminals.
3) When replacing the control pot, ensure that the flat on the control shaft is in
line with the grub screw.
4) Re-tighten the grub screw M3x5.
(See section 7 page 50)
Page 56