Bosch 11258VSR Instrucciones De Funcionamiento Y Seguridad página 8

BM 1619P00836 12-06
The selector dial allows the tool to be set for
various drilling/hammer drilling applications.
Rotate the selector dial right or left
depending on the below applications (Fig. 1).
Do
!
selection dial until the tool
come to a complete stop. Shifting during
CAUTION
rotation of the chuck can cause damage to
the tool.
Disconnect the plug from
!
the power source before
making any assembly, adjustments or
WARNING
changing accessories. Such preventive
safety measures reduce the risk of starting the
tool accidentally.
The 11258VSR Rotary Hammer utilizes
"SDS" drill bits. The "SDS" system efficiently
transfers drilling torque and maximizes the
energy delivered per hammer blow.
Clean the insert shank end of the accessory
to remove any debris, then lightly grease with
a light oil or lubricant.
Insert accessory into the tool holder through
the dust shield, while twisting and pushing
Accessories may be hot after
!
use. Avoid contact with skin
WARNING
and use proper protective gloves or cloth to
remove.
To remove an accessory, pull the locking
sleeve backwards (towards the rear of tool),
while pulling the accessory outward (Fig. 6).
All accessories should be wiped clean after
removing.
1/5/07 9:43 AM Page 8
DRILL/HAMMER DRILL SELECTION DIAL
not operate the
INSTALLING SDS-plus
REMOVING SDS-plus
Do not use demolition or chipping bits such
as bull points, chisels, spades, gouges, etc.
Drill only action: For drilling in
woods, metals, plastics or other
non concrete materials.
Drill with hammer action: For
drilling in concrete, asphalt, tile or
other similar hard materials.
ACCESSORIES
®
inward until it locks automatically into place.
Pull outward on the accessory to be certain it
is locked into the bit holder (Fig. 5).
FIG. 5
DUST SHIELD
ACCESSORIES
®
FIG. 6
LOCKING
SLEEVE
-8-