Using Your Machine; Description Of The Control Panel; Starting The Machine; Using The Functions - Brandt TI1FSOFT Manual De Instrucciones

3) USING YOUR MACHINE

a)

Description of the Control Panel

 The control keys are touch-sensitive. There is no need to apply pressure.
 Use the base of your finger and not the tip as shown in the pictures below.
 Push the slider with your finger to increase or decrease the power,
 You will hear a beep each time an action is recorded.
 The control panel must always be clean, dry and not covered by an object or a fabric.
Even a fine film of water may create malfunctions.
b) Starting the Machine
After having turned the machine on the audible alarm sounds and the screen displays "L" (cold)
or "H" (hot), indicating that the temperature of the induction plate is less than or higher than
60°C. Then press the Start/Stop key (6). The screen displays "----" meaning that the machine
is on standby and ready to be programmed. You can now use your induction plate.
Never place an empty pan on the ceramic plate without having turned the machine
on.
Note:
Once the machine is ready to be used, and if you don't press any other key during the next 30
seconds, it will turn off automatically for safety reasons. The screen will show "L" meaning that
the machine has gone back to standby.
In the same way if you place an incompatible pan on the plate the machine will show "E1", a
beep will be heard and the machine will turn off after 30 seconds.
c)

Using the Functions

 Timer
After selecting the level of heating power required press the timer key (2). The digital screen
will then show "00:00". Within 4 seconds press the +/- keys to adjust the cooking time. Each
press increases or decreases the time by 1 minute. If you hold down the key the time will
increase or decrease by 10 minute increments. The timer can be adjusted from 1 minute to 180
minutes. Once the set time has elapsed a beep is heard and the machine goes to standby. To
leave the timer mode, press the Timer key (2) again.
22