Using Your Machine; Use Of The Control Panel; Starting The Machine - Brandt TI2SLIM1 Manual De Instrucciones

3) USING YOUR MACHINE

a)

Use of the Control Panel

 The control keys are touch-sensitive. There is no need to apply pressure.
 Use the base of your finger and not the tip as shown in the pictures below.
 Slide your finger over the +/- key to increase or decrease the power.
 You will hear a beep each time an action is recorded.
 The control panel must always be clean, dry and not covered by an object or a fabric. Even
a fine film of water may create malfunctions.
b)

Starting the Machine

After turning the machine on, the alarm sounds and the screen displays "L" (cold). Then press
the Start/Stop key (7). The screen displays "----" meaning that the machine is on standby and
ready to be programmed. You can now use your induction plate.
Never place an empty pan on the ceramic without having turned the machine on.
Note:
After use, when the machine is switched off, the screen displays "L" or "H" and there will be a
ventilation noise for 60 seconds; once the time has elapsed, the noise will stop.
If you remove something from the machine during heating, the screen will display "E1" for 30
seconds before going into standby mode and displaying "L".
24