Start Up - Truper TAL-1/2N Manual De Instrucciones

Start Up

Bit Fitting
• Put the bit into the chuck until it stops. Fasten with the
chuck wrench and tighten alternately the chuck into
each of the orifices.
WARNING
Clean burrs and any other foreign
objects from the drill bit and drill bit, otherwise the drill
bit may not be tight and cause serious personal injury.
Turn on and operation control
• Intermittent operation:
Connect the plug into the power inlet.
Press the switch (A) to start the drill.
To stop, just release the switch.
• Continuous Operation:
Connect the plug into the power inlet.
Press the switch (A) and block it pressing the continuous use button (B).
To stop, press and then, release the switch.
• Speed Level Selection:
The tool speed can be regulated with the pressure onto the switch. The pressure
exercised will make the speed to increase.
Rotation direction
• The rotation direction button is located on both sides of the drill (C).
• To make the drill turning forwards and drill, press the rotation direction
button with the arrow pointing towards the chuck.
• To make it reversible press the rotation direction button with the arrow
pointing towards the drill handle.
• The reverse rotation enables the drill to loosen screws and nuts turning the
drill into a screwdriver. When using the drill in the screwdriver mode do not
exercise too much pressure onto the switch.
• Changing the rotation direction can only be carried out when the switch is
not pressed.
Adjusting auxiliary handle and depth control rod
• Turn the auxiliary handle as indicated in the figure. When the
auxiliary handle mount is loose, turn it into the desired position.
Turn the auxiliary handle in a reverse direction to fix it in the new
position.
• To move the depth control rod, loosen the mount as explained in
the previous paragraph. Once loose push the rod to the desired
depth. Tighten the auxiliary handle to fix the rod into the new
position.
Bit
Chuck
Chuck
wrench
B
A
C
Rotation selector button
in the drilling position.
7
ENGLISH