Description Of The Machine; Control Switches - Lavorwash TEKNA Manual Del Usuario

> DESCRIPTION OF THE MACHINE
①
Electropump switch
②
Regulator burner
③
Detergent regulator
④
Pressure gauge
⑤
Burner switch
⑥
Pilot lights (OPTIONAL)
⑦
High pressure water outlet
⑧
Water inlet + filter
⑨
Gun
⑩
Lance
⑪
High pressure hose
⑫
Rubber hose fitting
⑬
Nozzle
⑭
Diesel tank
⑮
Detergent tank
⑯
Liquid softener tank
> CONTROL COMPONENTS

CONTROL SWITCHES

①
Motor pump switch
②
Burner switch with regulator
③
Detergent regulator
⑤
Burner switch
⑥
Pilot lights: DIESEL shortage (OPTIONAL)
⑥
A: Motor pump ON green pilot light
⑥
B: Leak pilot light
- flashes when the pistol lever is repeatedly
operated in a short time or when a leak occurs
in the high pressure circuit. Remove the leak,
referring to an authorized service centre.
- remains ON when the machine is left in
stand-by for over 20 minutes.
Switch on and off the motor pump switch.
⑥
C: Burner switch
- flashes when the gasoil tank is empty; the
burner is stopped. Refuel.
- remains ON when the burner switches on.
IMPORTANT: This water cleaner is equipped
with the A.S.S. (Automatic Stop System), which
stops the machine during the bypass phase.
To start the water cleaner, it is therefore necessary
to set the switch on position "ON"; after that
press the pistol trigger: the Automatic Stop
System will start the machine and will stop it
automatically when the trigger is released. It
is advisable to put on the safety of the pistol
trigger whenever the machine is stopped, in
order to avoid unintentional starting.
• Any automatic start of the machine without
pressing the gun trigger is attributable to
air bubbles in the water or other similar
phenomena which do not imply the existence
of any defects in the machine.
• Do not leave the appliance unattended during
the standby for more than 5 minutes. Contrarily,
for the safety of the appliance it is necessary to
re-turn the switch into the OFF position.
• Please check that the coupling of the high
pressure hose with the appliance and the
gun supplied as standard equipments made
correctly, that is to say without any water leak.
If the appliance is equipped with a pressure
regulator:
• when the pressure is set to minimum the A.S.S.
may not trigger. Therefore, do not allow the
appliance to function in by-pass for more than
1 minute.
• do not act on the gun lever too frequently (this
may cause a malfunction).
> INSTALLATION AND START-UP
(fig. A)
FILLING UP WITH FUEL
Fill the tank with the fuel indicated on the technical
data plate (Diesel)
Avoid that the tank is empty when the machine is
running in order not to damage the fuel pump.
• WARNING: Incorrect fuel shall not used as they as
provide hazard.
FILLING UP WITH DETERGENT
the detergent tank with the suggested products, su-
itable for the kind of washing to be carried out.
• WARNING: Make use only of liquid detergent, do not
(if fitted)
absolutely use acid or too much alkaline products. We
suggest you to make use of our products, which have
been studied for the use with washer machines.
> INSTALLATION
(fig. CDEFG)
• Check that the master switch is turned to
EN
21