SATA 51071 Manual Del Uso página 20

Llave de impacto de batería de litio de torque grande de 18v de 1/2" (giro de 2 segmentos)
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 77
A
F
6) Replacement of carbon brush:
Please replace the carbon brush when it is worn to less than 5mm.
How to replace:
A)Remove the carbon brush cap with the screwdriver (Fig. F)
B)Take out the carbon brushes on both sides ( Fig. G)
C)Put the same new carbon brushes on both sides and cover the carbon brush cap ( Fig. H)
D)Tighten the carbon brush cap with the screwdriver (Fig. 1)
Question and answer:
1)Why does the machine not operate after the switch is pressed?
The reversing yoke on the upper part of switch is locked. Turn it to the position where the rotation direction is in need, and then press
the button to rotate the machine.
2) Why is the service life of same kind of battery pack different?
As mentioned above, if a battery pack is left unused for a long time, its service life may be shortened. This is the matter of charging
frequency. Several times of charging and use may improve the situation. In case of heavy work, e.g. when the large bolt is tightened,
the battery pack will run out soon. Do not charge the machine at the temperature below 0° C or above 45° C. Otherwise, the
performance of battery pack will be affected.
Maintenance:
Be sure to pull off the plug before repairing or replacing the machine.
The electric tool does not require additional lubrication or other maintenance. Do not wash the electric tool with water or chemical
cleaner. Wipe it with a dry cloth. Tool shall be stored under the dry conditions and the vent of motor shall be kept clean. Try not to use it
in a dusty environment.
20
51071/51072
B
G
中文
EN
H
C
DE
RU
KO
PT
JA
I
ES

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

51072

Tabla de contenido