mabe MMI09CDBWCCCHI8 Manual Del Propietário página 87

4. Connecting the cable
• Indoor Unit
Connect the power cord to the indoor unit by connecting the
wires to the terminals on the control board individually in accor-
dance with the outdoor unit connection.
Note: For some models, it is necessary to remove the cabinet to
connect to the indoor unit terminal.
• Outdoor Unit
1. Remove the access door from the unit by loosening the screw.
Connect the wires to the terminals on the control board indi-
vidually as follows.
2. Secure the power cord onto the control board with cable
clamp.
3. Reinstall the access door to its original position using the
screw.
4. Use a recognized circuit breaker for 24K model between the
power source and the unit. A disconnecting device to ad-
equately disconnect all supply lines must be fitted.
The illustrations in this manual are based on the exterior appear-
ance of a model, consequently, their appearance could differ from
that of the model you acquired.
wifi ready (no included)
To enable the WiFi function it will be necessary to acquire and
connect the USB module to the device. Call your authorized service
provider.
87