Steel Heat Shield Guards - ESAB PT-27 Serie Manual Del Usuario

seCTIoN 3
3.3

steel heat shield Guards

STEEL GUARD
STAND OFF GUIDE
P/N 140
GUIDE AGAINST
STRAIGHT EDGE
OR FREE-HAND
CUT
figure 3-2. Installation and operation of steel heat shield Guards
ADJUST GUIDE BY TURNING
IN A CLOCKWISE DIRECTION
ONLY. THIS WILL PREVENT
ACCIDENTAL LOOSENING
OF SHIELD.
THIN GAUGE MATERIALS
CAN BE CUT WITH 1/16" (.6 mm)
TORCH-TO-WORK DISTANCE
ADJUST TO /16" (4.8 mm) FOR
MATERIALS OVER 1/4" (6.4 mm) THICK
1/16" (.6 mm) TO 1/4" (6.4 mm)
TORCH-TO-WORK
STEEL GUARD (P/N 544) PRO-
TECTS SHIELD WHEN CUTTING
OR GOUGING.

AsseMBLY & oPeRATIoN
IF GUIDE IS TOO TIGHT ON
SHIELD, OPEN SLOT WITH
SCREWDRIVER.
IF TOO LOOSE, CLOSE
SLOT WITH VISE OR
LARGE PLIERS.