ESAB PT-27 Serie Manual Del Usuario página 27

seCTIoN 4
COVER
To replace - Remove switch band from torch (see figure 4-). Pull the switch and end plug out of the cover. Snip
the white leads from the switch (leads supplied with the torch cable bundle are sufficiently long to allow cut-
ting). Crimp or solder the replacement switch to the leads.
CRIMP OR SOLDER
SWITCH
sWITCh KIT P/N 0558005509
Switch can be mounted on top or bottom of handle.
figure 4-5. switch Replacement Detail
7
MAINTeNANCe
WHITE LEADS
END PLUG
Note: