Storage And Service; Warranty Registration - Tripp-Lite SmartPro 3U Manual De Operación

Storage and Service

Warranty Registration

Visit www.tripplite.com/warranty today to register the warranty for your new Tripp Lite product. You'll be
automatically entered into a drawing for a chance to win a FREE Tripp Lite product!*
* No purchase necessary. Void where prohibited. Some restrictions apply. See website for details.
Storage
Before storing your UPS, place it in the OFF mode by reversing the Connection procedure: use the POWER button to
place the UPS in STANDBY mode; unplug the UPS; set the double-pole input breaker to the "OFF" position; disconnect
the external battery pack. If you store your UPS for an extended period of time, recharge the UPS batteries once every
three months by following Steps 1, 2 and 3 in the Connection section and allowing the UPS to charge its batteries for 4-6
hours before placing it back in storage. If you leave your UPS batteries discharged for an extended period of time, they
will suffer a permanent loss of capacity.
Service
A variety of Extended Warranty and On-Site Service Programs are also available from Tripp Lite. For more information on
service, visit www.tripplite.com/support. Before returning your product for service, follow these steps:
1. Review the installation and operation procedures in this manual to insure that the service problem does not originate from
a misreading of the instructions.
2. If the problem continues, do not contact or return the product to the dealer. Instead, visit www.tripplite.com/support.
3. If the problem requires service, visit www.tripplite.com/support and click the Product Returns link. From here you can
request a Returned Material Authorization (RMA) number, which is required for service. This simple on-line form will ask
for your unit's model and serial numbers, along with other general purchaser information. The RMA number, along with
shipping instructions will be emailed to you. Any damages (direct, indirect, special or consequential) to the product incurred
during shipment to Tripp Lite or an authorized Tripp Lite service center is not covered under warranty. Products shipped to
Tripp Lite or an authorized Tripp Lite service center must have transportation charges prepaid. Mark the RMA number on
the outside of the package. If the product is within its warranty period, enclose a copy of your sales receipt. Return the
product for service using an insured carrier to the address given to you when you request the RMA.
Specifications
Series # (Power Module):
Series # (Battery Pack):
Output Capacity (VA/Watts):
Battery Runtime in Minutes (Half Load/Full Load):
Battery Recharge Time:
Approvals:
* The SMART5000RT3U features a 30A plug. A trained technician may replace it with an user-supplied 50A plug.
** Battery Runtime listed assumes connection to a single BP48V60RT3U external battery pack. Battery Runtime can be increased with additional external battery packs. Adding external battery packs will also
increase recharge time.
Input Voltage (208V); Input Frequency (60 Hz); Online Input Voltage Range (151-260 volts); Voltage-Regulated Output Voltage Range (208/120V ±9%); On-Battery Output Voltage Range (208/120V ± 5%);
Output Waveform Line Mode (filtered sinewave); Output Waveform Battery Mode (sine wave); AC Surge Suppression (exceeds IEEE 587 Cat. A & B standards); AC Noise Attenuation (>40 dB); AC Surge
Protection Modes (H to N, H to G, N to G); Compatible Battery Packs (BP48V60RT3U).
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to
correct the interference at his own expense.
Tripp Lite has a policy of continuous improvement. Specifications are subject to change without notice.
Note on Labeling
Two symbols are used on the label.
V~ : AC Voltage
V : DC Voltage
SMART5000RT3U
with 30A plug*
AGSM5000Y3U31
AGBP4860Y3U
4475(@208+120V)/4000 5000(@208V), 4800(@120V)/4000
38+/16+**
2-4 hrs.**
UL, cUL, NOM
10
SMART5000RT3U
with 50A plug*
AGSM5000Y3U31
AGBP4860Y3U
38+/16+**
2-4 hrs.**
UL, cUL, NOM
201112100 93-2159-EN