Optional Installation - Tripp-Lite SmartPro SLT Manual Del Propietário

201111068 93-3154.qxd

Optional Installation

These connections are optional. Your UPS will function properly without these connections.
1
USB and RS-232 Serial
Communications
Use the included USB cable
cable to connect the communication port on
1b
your computer to the communication port of your
UPS. Install on your computer the Tripp Lite
PowerAlert Software appropriate to your
computer's operating system. Consult your
PowerAlert manual for more information.
2
Telephone/Network Protection Jacks
Your UPS has jacks that protect against surges
over a telephone line or a network dataline. Using
telephone network data cables, connect your wall
jack to the UPS jack marked "IN." Connect your
equipment to the UPS jack marked "OUT." Make
sure the equipment you connect to the UPS's jacks
is also protected against surges on the AC line.
Not compatible with PoE (Power Over Ethernet) applications.
11/4/2011 2:55 PM Page 4
and/or DB9 serial
1a
4
1a
1b
2