Safety Warnings; Function - Trix 420 Serie Manual De Instrucciones

Ocultar thumbs Ver también para 420 Serie:
Tabla de contenido

Publicidad

Function

• This model is designed for operation with H0 2-rail DC
systems (track according to NEM standards) with con-
ventional DC power packs.
• This locomotive comes equipped with a Trix connector for
digital operation and can have the Trix locomotive decoder
installed in it.
• Headlights change over with the direction of travel and vary in
brightness according to the voltage present in the track.
• Functions in conjunction with the decoder:
– Headlights/Red marker light
– Electrical pickup changeover with the Trix 66849 decoder
The following CVs must be set in the decoder to use the
electrical pickup changeover feature: CV61 =1
The electrical pickup changeover feature will now work in
digital and analog with either track or catenary operation.
The necessary maintenance that will comes due with normal
operation is described below. Please see your authorized Trix
dealer for repairs or spare parts.
Safety Information
• Please make note of the safety information in the instructions
for your operating system.
• Trix motor vehicles must not be operated on digital systems
without an in-built engine decoder (Motor can be damaged!).
• The feeder track must be equipped to prevent interference
with radio and television reception, when the locomotive is
to be run in conventional operation. The 611 655 interference
suppression set is to be used for this purpose.
The interference suppression set is not suitable for digital
operation.
No warranty or damage claims shall be accepted in those cases where
parts neither manufactured nor approved by Trix have been installed in
Trix products or where Trix products have been converted in such a way
CV62 =2
that the non-Trix parts or the conversion were causal to the defects and /
or damage arising. The burden of presenting evidence and the burden of
proof thereof, that the installation of non-Trix parts or the conversion in or
of Trix products was not causal to the defects and / or damage arising, is
borne by the person and/or company responsible for the installation and /
or conversion, or by the customer.
9

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

22622

Tabla de contenido