HQ-Power VDPLW57201 Manual Del Usuario página 5

6. Overview
Refer to the illustrations on page 2 of this manual.
1 MODE selection button
2 UP button
3 DOWN button
4 display
7. Operation
Refer to the illustrations on page 2 of this manual.
• The VDPLW57201 can work stand-alone with fixed colour output or controlled by an external DMX-controller
(not incl.).
• The VDPLW57201 in master mode generates DMX values on the DMX output [6]. Linked devices will follow
the behaviour of the master when they are placed in slave mode.
a) Colour mode "C" (master)
• Press the MODE selection button [1] until the first digit of display [4] shows "C".
• Use the UP [2] or DOWN button [3] to select all-off or one of the twelve preset colours (see table below).
C 0
C 1
C 2
C 3
C 4
C 5
C 6
• The selected setting is automatically stored in memory.
b) Slave mode "SLA"
• Press the MODE selection button [1] until the display [4] shows "SLA". This sets the units DMX-channel to
001.
• While a DMX-signal is received, an LED on the lower right will be on.
• Slave mode can also be used fro remotely controlling the unit if no specific DMX address is required and
channels 001~003 can be used as default.
c) DMX mode "d"
• Press the MODE selection button [1] until the display [4] shows "d". After a few seconds, the display will
show the DMX starting address.
• All DMX-controlled devices need a digital start address so that the correct device responds to the signals. This
digital start address is the channel number from which the device starts to "listen" to the DMX controller. The
same starting address can be used for a whole group of devices or an individual address can be set for every
device.
• When all devices have the same address, all the units will "listen" to the control signal on one particular
channel. In other words: changing the settings of one channel will affect all devices simultaneously. If you set
individual addresses, each device will "listen" to a separate channel number. Changing the settings of one
channel will only affect the device in question.
• In case of the 5-channel VDPLW57201, you will have to set the start address of the first unit to 001
(CH1~4), the second unit to 006 (1 + 5) (CH5~8), the third to 011 (6 + 5) (CH9~12), and so on.
• Use the UP- [2] or DOWN-button [3] to select a DMX starting address. After selecting, it takes ± 3 seconds
before the address becomes active. The display shows alternately the address and "d".
• The selected address is automatically stored in memory.
• While a DMX-signal is received, an LED on the lower right will be on.
• The unit receives DMX values in a packet of 5 channels and mirrors this data on the DMX output [6]:
DMX channel
CH1
CH2
CH3
CH4
CH5
21.04.2010
all off
red
green
blue
yellow
pink
turquoise
Value Range
000-255
000-255
000-255
0-100
0-100
VDPLW57201
5 DMX input
6 DMX output
7 power output
8 power input
C 7 lime
C 8 orange
C 9 marine
C10 frog
C11 lavender
C12 candy
C13 white
Function
red (Out1 level)
green (Out2 level)
blue (Out3 level)
dimmer
shutter
5
©Velleman nv