Página 1
NOTE to Installer: Please leave this manual with the homeowner VDLT 16 INSTRUCTION MANUAL We’ll Make It Stress-Free If you have any questions along the way, just give us a call. 1-800-359-5520. We’re ready to help!
Página 2
MORE than? (68.0 kg) or concrete block. No — Perfect! Yes — This mount is NOT compatible. Visit MountFinder.Sanus.com For walls with 110 lbs. or call 1-800-359-5520 to find a compatible mount. steel studs. (49.8 kg)
Página 3
Do you have all the tools 1/2 in. needed? (13 mm) Tape Pencil Level Screwdriver Electric Drill Socket Measure Wrench 3/8 in. 7/32 in. 1/2 in. (10 mm) (13 mm) (5.5 mm) Concrete Steel Wood Stud Stud Drill Bit Drill Bit Hammer Drill Bit Finder...
Página 4
STEP 1 Attach TV Bracket to TV WARNING: This product contains small items that could be a choking hazard if swallowed. Before starting assembly, verify all parts are included and undamaged. If any parts are missing or damaged, do not return the damaged item to your dealer; contact Customer Service. Never use damaged parts! NOTE: Not all hardware included will be used.
Página 5
1.1 Select TV Screws 1.2 Determine Spacer Need TV Bracket TV Bracket Flat Back Cables Round Back Inset Holes TV Bracket TV Bracket TV Bracket Too Short Correct Too Long For flat-back TVs, no For rounded-back TVs, cable interference or CAUTION: spacers inset holes, spacers...
Página 6
1.3 Attach TV Bracket Assembly to TV POSITION SECURELY TIGHTEN Flat-back TVs Rounded-back TVs / Extra Space The tilt tension knob on TV brackets TIP: should be oriented to the outside edges. Center the TV brackets over your TV's mounting hole Install using the spacer, screw and washer combination you pattern - making sure the brackets are at the same height.
Página 7
STEP 2 Attach Wall Plate to Wall WARNING: This product contains small items that could be a choking hazard if swallowed. Before starting assembly, verify all parts are included and undamaged. If any parts are missing or damaged, do not return the damaged item to your dealer; contact Customer Service. Never use damaged parts! NOTE: Not all hardware included will be used.
STEP 2A Wood Stud Installation CAUTION: Avoid potential Min. 1 ½ in. (3.8 cm) personal injury or property damage! ● Drywall covering the wall Min. 16 in. (40.6 cm) Min. 3 ½ in. (8.9 cm) must not exceed 5/8 in. (1.5 cm) ●...
Página 9
CAUTION: Be sure you drill into the CENTER of the stud. TIP: our HeightFinder at sanus.com [www.sanus.com/1172]. Place the wall plate template at your desired height and position the Drill the four pilot holes using a 7/32 in. (5.5 mm) diameter drill bit.
Página 10
STEP 2A (continued) REMOVE TEMPLATE SECURELY TIGHTEN CAUTION: Avoid potential personal injury or property damage! All four lag bolts MUST BE firmly tightened to prevent unwanted movement of the wall plate . Ensure the wall plate is securely fastened to the wall before continuing on to the next step. Install the four lag bolts and firmly tighten until they are Remove the wall plate template and discard.
Página 11
Min. 16 in. (40.6 cm) To calculate your precise wall plate location, check out TIP: TIP: our HeightFinder at sanus.com [www.sanus.com/1172]. Position the wall plate template on the wall at your desired height. Level and mark the hole locations.
Página 12
STEP 2B (continued) DRILL REMOVE TEMPLATE 3 in. (7.6 cm) 3/8 in. (10 mm) CAUTION: CAUTION: Never drill into the mortar between blocks. Never drill into the mortar between blocks. Drill four pilot holes using a 3/8 in. (10 mm) diameter drill bit. Remove the wall plate template and discard.
Página 13
INSERT ANCHORS SECURELY TIGHTEN CAUTION: Avoid potential personal injury or property damage! All four lag bolts MUST BE firmly tightened to prevent Be sure the anchors are seated flush unwanted movement of the wall plate . Ensure the wall plate is CAUTION: CAUTION: with the concrete surface.
Página 14
STEP 2C Steel Stud Installation Kit (NOT INCLUDED) CAUTION: Avoid potential personal injury or property damage! Min. 16 in. (40.6 cm) ● Studs must be at least 2x4 / 25 ga. 1/4-20 x 1.75 ● If back side of wall is unfinished, drywall must be installed to a minimum .734 x .312 x .065 in.
Página 15
CAUTION: Be sure you drill into the CENTER of the stud. TIP: our Height Finder at sanus.com [www.san.us/1172]. Drill the four pilot holes using a 1/2 in. (13 mm) diameter drill bit. Place the wall plate template at your desired height and position the IMPORTANT: Pilot holes must be drilled to a depth of 1 in.
Página 16
STEP 2C (continued) INSTALL ANCHORS SECURELY TIGHTEN CAUTION: Avoid potential personal injury or property damage! All four screws MUST BE firmly tightened to prevent CAUTION: Be sure cap unwanted movement of the wall plate . Ensure the wall plate is seated against the drywall surface.
Página 17
STEP 3 Attach TV to Wall Plate HANG ATTACH HEAVY! You may need assistance with this step. CAUTION: CAUTION: Avoid potential personal injury or property damage! Avoid potential personal injury or property damage! For CONCRETE APPLICATIONS: Always make sure TV brackets are in the locked TV brackets MUST remain centered in wall plate...
Página 18
Manage Cables INSTALL CABLES TIP: TIP: Extend the TV outward AND tilt the TV up or down to gain better access to the back of the TV. Move your TV to various positions, as needed to attach your cables, then adjust the TV as desired.
Página 19
Adjustments LEVEL HEIGHT To level your TV, turn Adjust the height the level adjustment by turning the level screw on the top adjustment screw RAISE LOWER of either TV bracket on the top of both TV RAISE RAISE to raise or brackets LOWER LOWER...
Página 20
TILT EXTEND / RETRACT Your TV should adjust easily when moved, then stay in place. Adjust the tilt tension knob your TV naturally tilts up or down. NOTE: If you do not intend to adjust the tilt for different viewing locations, you can tighten the CAUTION: Avoid potential...
Página 21
TV LATERAL SHIFT REMOVING THE TV HEAVY HEAVY ! You may need assistance with this step. ! You may need assistance with this step. Disconnect all cables from the TV. CAUTION: Avoid potential To unlock the TV from the wall plate: Pull down and hold both release tabs while gently pulling personal injury or property damage! the bottom of the TV away from the wall.
Página 22
Troubleshooting If you are uncertain about your hardware selection, TV Supplied contact Customer Service at 1-800-359-5520. TV supplied spacers Spacers : Use your TV supplied spacer/adapter for flat back TVs : Use your TV supplied spacer/adapter and spacer for: (AND you want your TV closer to the wall).
Página 24
En paredes Sí. Este soporte NO es compatible. (incluidos los 68,0 kg hormigón sólido o con montantes 49,8 kg Visite MountFinder.Sanus.com o llame al 1-800-359-5520 pesa bloques de hormigón de acero accesorios) (150 lb) (110 lb) para encontrar un soporte compatible.
Español PASO 1 Fijar el soporte del televisor al televisor PÁGINA 4 ADVERTENCIA: Este producto contiene piezas pequeñas que, en caso de ser tragadas, podrían producir asfixia. Antes de iniciar el ensamblaje, compruebe que todas las piezas estén incluidas y en buenas condiciones. Si faltan piezas o alguna está dañada, no devuelva el artículo al distribuidor. Póngase en contacto con el servicio de atención al cliente.
Página 26
COLOCAR LA PLANTILLA CONSEJO: Para calcular la ubicación concreta de la placa mural, pruebe nuestra herramienta HeightFinder disponible en sanus.com [www.sanus.com/1172]. Coloque la plantilla de la placa mural a la altura que desee y ubique los orificios muescados sobre las líneas centrales del montante. Nivele y marque la ubicación de los orificios.
Página 27
COLOCAR LA PLANTILLA CONSEJO: ara calcular la ubicación concreta de la placa mural, pruebe nuestra herramienta HeightFinder disponible en sanus.com [www.sanus.com/1172]. Coloque la plantilla de la placa mural en la pared a la altura que desee. Nivele y marque la ubicación de los orificios.
Página 28
COLOCAR LA PLANTILLA CONSEJO: Para calcular la ubicación concreta de la placa mural, pruebe nuestra herramienta HeightFinder disponible en sanus.com [www.sanus.com/1172]. Coloque la plantilla de la placa mural a la altura que desee y ubique los orificios muescados sobre las líneas centrales del montante. Nivele y marque la ubicación de los orificios.
Español PASO 3 Fijar el televisor en la placa mural PÁGINA 17 CUELGUE EL TELEVISOR EN LA PLACA MURAL PRECAUCIÓN: Evite posibles lesiones físicas y daños materiales. Para APLICACIONES EN HORMIGÓN: Los soportes de televisor DEBEN estar centrados en la placa mural NOTA: Para APLICACIONES SOBRE MONTANTES DE MADERA, los soportes de televisor se pueden deslizar a cualquier parte de la placa...
Español EXTENDER / RETRAER PRECAUCIÓN: Evite posibles lesiones físicas y daños materiales. Los soportes del televisor pueden contener puntos de compresión durante la operación. Mantenga los dedos alejados de los puntos de compresión al retraer el televisor. (observe las flechas) DESPLAZAMIENTO LATERAL DEL TELEVISOR ¡ELEMENTO PESADO! Es posible que necesite ayuda en este paso.
Página 32
Thank you for choosing SANUS! Please take a moment to let us know how we did: Call us: 1-800-359-5520 Email us: info@sanus.com Leave a review: sanus.com Find us on Facebook: SANUS Follow us on Twitter: @sanussystems Milestone AV Technologies and its affiliated corporations and subsidiaries (collectively, “Milestone”), intend to make this manual accurate and complete. However, Milestone makes no claim that the information contained herein covers all details, conditions, or variations.