Ryobi TS1143L Manual Del Operador página 20

SQUARING THE BLADE TO THE MITER TABLE
See Figures 22 - 24.
 Unplug the saw.
 Pull the saw arm all the way down and engage the lock
pin to hold the saw arm in transport position.
 Unlock the miter lock lever.
 Rotate the miter table until the pointer aligns with zero
detent on the miter scale.
 Lock the miter lock.
 Loosen bevel lock knob and set saw arm at 0
set 90 to miter table). Tighten bevel lock knob at stop.
°
 Place a square against the miter table and the flat part
of saw blade.
NOTE: Make sure that the square contacts the flat part
of the saw blade, not the blade teeth.
 Rotate the blade by hand and check the blade-to-table
alignment at several points.
 The edge of the square and the saw blade should be
parallel as shown in figure 22.
 If the top or bottom of the saw blade angles away from
the square as shown in figures 23 and 24, adjustments
are needed.
 Loosen the bevel lock knob.
COMBINATION
SQUARE
POSITIVE STOP
ADJUSTMENT SCREWS
CORRECT VIEW OF BLADE
SQUARE WITH MITER TABLE
ASSEMBLY
bevel (blade
°
BLADE
MITER
TABLE
BEVEL
LOCK KNOB
Fig. 22
20 - English
 Adjust positive stop adjustment screw to bring saw
blade into alignment with the square. See Positive Stop
Adjustment in the Adjustments section.
 Retighten bevel lock knob. Recheck blade-to-table
alignment.
NOTE: The above procedure can be used to check blade
squareness of the saw blade to the miter table at both 0
and 45 angles.
°
The saw has two scale indicators, one on the bevel scale and
one on the miter scale. After squaring adjustments have been
made, it may be necessary to loosen the indicator screws
and reset them to zero. See figures 20 and 21 .
COMBINATION
BEVEL
LOCK KNOB
VIEW OF BLADE NOT SQUARE WITH MITER
TABLE, ADJUSTMENTS ARE REQUIRED
COMBINATION
BEVEL
LOCK KNOB
VIEW OF BLADE NOT SQUARE WITH MITER TABLE,
ADJUSTMENTS ARE REQUIRED
BLADE
SQUARE
MITER
TABLE
BLADE
SQUARE
MITER
TABLE
°
Fig. 23
Fig. 24