Intended Use
This device is intended to chop foodstuffs which are suitable for
cutting.
It is only designed for this use and should only be used for this
intended purpose.
Only use this device as instructed in this user manual. Do not
use this device commercially.
No other use is intended and can cause damage or personal
injuries.
Clatronic International GmbH is not responsible for any
damages incurred due to improper use
Unpack Device
•
Take the device out of its packaging.
•
Remove all packaging materials, such as foils, filling
materials, cable ties and cartons.
•
Check that all accessories are included in the box.
NOTE:
Clean manufacturing residues and dust from the device as
described under "Cleaning".
Start-Up
1. Prepare the dish. Refer to the table below.
2. Place the rubber mat on a level, flat surface. Place the
glass container on the rubber mat.
3. Use one knife or both knives depending on the quantity of
the food. Fit the knife (or the knives) carefully into the glass
bowl:
3.1. Fit the knife with the shaft onto the glass pin in the
center of the container.
3.2. If required, fit the second knife with the blades facing
down onto the shaft of the first knife.
4. Empty the desired foodstuffs into the container.
NOTE:
Do not overfill the container; otherwise the foodstuffs
cannot be properly chopped (quantities see table)!
5. Place the safety cover onto the container in such way that
the blade shaft rests in the recess. The safety cover is
properly positioned if it cannot be moved.
NOTE:
Before use, always check that the silicone seal fits
correctly.
6. Place the motor unit on the cover. In doing so, use the
recesses in the safety cover.
7. Electric Connection
Connect the mains plug to a properly installed and earthed
220-240 V~, 50/60 Hz wall outlet.
NOTE:
•
The motor unit is fitted with a safety switch.
•
If the device cannot be switched on, check that the
motor unit, safety cover and blade are fitted correctly.
8. Hold the motor housing in your hand and press the LOW or
HIGH button at the same time.
LOW = low speed
HIGH = high speed.
The unit starts up.
CAUTION:
This device is suitable for short time operation (KB) of
maximum 20 seconds. Leave to cool down for at least
2 minutes before using the device again.
NOTE:
PULSE OPERATION: Briefly press and release the
switch for pulse operation. Use the device in this mode for
maximum 1 minute. Leave to cool down for at least
2 minutes before using the device again!
9. After chopping, take your hand off the motor unit.
Disconnect from mains power supply.
10. Remove the motor unit from the transparent container.
11. Lift off the safety cover and carefully remove the blade.
12. Now you can empty the contents in the transparent
container.
Crushing ice: The blades in the mixing bowl are suitable for
breaking ice cubes. Fill the container no higher than the
0.75 marking with ice cubes. Only crush ice cubes in pulse
mode.
Table
Food
Preparation
Shelled,
Boiled eggs
quartered
Herbs
Walnuts/
Without
hazelnuts
nutshells!
Almonds
Without shells!
Garlic
Peeled
Onions
2 cm cubes
Parsley
Wash, destalk
Bread
2 cm cubes
(breadcrumbs)
2 cm cubes,
without bones,
Meat
skin and
sinews!
Max.
Max. Duration
Quantity
450 g
10 sec
(1/4 pieces)
300 g
15 sec or pulse
300 g
15 sec.
300 g
15 sec
300 g
15 sec or pulse
300 g
5-10 sec or pulse
60 g
10 sec
80 g
15 sec or pulse
300 g
15 sec or pulse
21