Nozzle Assembly - Chapin 61575 Manual De Uso Y Cuidado

SPRAYER COMPONENTS & USE INFORMATION

NOZZLE ASSEMBLY

Figure 1
Unscrew the nozzle cap (1) from the nozzle body (3) with retaining nut (2) fastened tightly to the elbow
(5). Unscrew the retaining nut (2). Push the nozzle body (3) with the nozzle gasket (4) out of the
retaining nut (2). To reinstall the nozzle, reverse the above instructions.
Figure 2
Unscrew the retaining nut from the elbow and push the fan nozzle tip and gasket out of the retaining nut.
To reinstall the nozzle, reverse the above instructions.
1. Poly
Nozzle Cap
WAND ASSEMBLY
1. Make sure the o-ring is installed on the end of the wand.
Insert the wand into shut-off valve.
2. Turn and tighten the retaining nut clock-wise onto the shut-off valve.
Retaining Nut
2. Retaining
Nut
3. Nozzle
Body
4. Nozzle
Gasket
5. Elbow
Figure 1
O-ring
Wand
Retaining Nut
Fan Nozzle Tip
Nozzle
Gasket
Elbow
Shut-off
Valve
2E
Figure 2