Product Overview; Charging The Battery - Toro Recycler Manual Del Operador

Important: Do not overfill the crankcase with
oil and run the engine. Drain the excess oil until
the oil level on the dipstick reads Full.
6. Install the dipstick into the oil fill tube securely.
Important: Change the engine oil after the first
5 operating hours ; change it yearly thereafter.
Refer to Changing the Engine Oil.
3

Charging the Battery

No Parts Required
Procedure
Electric-start models only
Refer to Charging the Battery in the Maintenance
section.

Product Overview

1. Handle
2. Blade control bar
3. Ignition key (electric-start
models only)
4. Fuel tank cap
5. Oil fill/dipstick
6. Washout port (not shown) 13. Recoil start handle
7. Spark plug
1. Grass bag
2. Side discharge chute
6
Figure 5
8. Cutting height lever (4)
9. Air filter
10. Side-discharge deflector
11. Bag-on-demand lever
12. Handle knob (2)
Figure 6
3. Battery charger
(electric-start models
only)