BH FITNESS H862H Instrucciones De Montaje Y Utilización página 11

pull the control knob back and without
releasing it, move the saddle post up
or down, Fig.6. When it is at the right
height release the knob and it will lock
into a hole on the saddle post. Tighten
it up by turning the control knob (91) in
a clockwise direction.
HORIZONTAL ADJUSTMENT.
To adjust the saddle's horizontal
position, loosen the control knob on
the saddle's horizontal bar and move
the saddle, along with the bar, into the
desired position, then tighten the
control knob securely, Fig.6.
TILTING THE SADDLE.
The saddle can be tilted backward or
forward. Loosen off nut (Z) shown in
Fig.6, located under the saddle, tilt the
saddle into the desired position and
then retighten the nut securely.
Do not adjust the tilt of the saddle
while you are still sitting on it.
7. FITTING THE MONITOR.-
Attach the handlebar
bracket of post tube, then fixed the
handle with Allen screw (66), flat
washer 65) and spring washer (63)
securely.
Bring the monitor
handlebar stem (17) Fig.8, connect
the two terminals coming out of the
handlebar stem (17) and the monitor
(71), Fig.8.
Insert the monitor (71) onto the
handlebar stem (13), as shown in
Fig.8, making sure not to pinch any of
the cables. Fit the bolts (73) making
28 into the
(71) to the
sure that the handlebar is aligned
correctly, securely tighten all of the
bolts on the handlebar stem including
the bolts at the base which were left
hand tight in point 4.
LEVELLING.-
Once the unit has been placed into its
final position, make sure that it sits flat
on the floor and that it is level. This is
achieved by screwing the adjustable
foot (51) up or down, Fig.9.
MOVEMENT & STORAGE.-
The unit is equipped with wheels (38)
to make it easier to move about. The
two wheels at the front of the unit
make it easier to place the unit in any
chosen position, as shown in the
Fig.10.
Store it in a dry place, preferably not
subject to changes in temperature.
MAINS CONNECTION.-
Insert the jack (m) on the transformer
(75) into the connection hole on the
main body (1) (bottom, rear of the
machine)
transformer into a 230 V mains supply,
Fig.11.
Do not hesitate to get touch with the
Technical Assistance Service if you
have any queries by phoning customer
services (see last page in manual)
BH RESERVES THE RIGHT TO
MODIFY THE SPECIFICATIONS OF
ITS PRODUCTS WITHOUT PRIOR
NOTICE
11
and then plug the