Tanaka TCG 24EBSP SL Manual De Instrucciones página 14

English
Spark plug (Fig. 24)
The spark plug condition is infl uenced by:
○ An incorrect carburetor setting
○ Wrong fuel mixture (too much oil in the gasoline)
○ A dirty air fi lter
○ Hard running conditions (such as cold weather)
These factors cause deposits on the spark plug
electrodes, which may result in malfunction and
starting diffi culties. If the engine is low on power,
diffi cult to start or runs poorly at idling speed, always
check the spark plug fi rst. If the spark plug is dirty,
clean it and check the electrode gap. Re-adjust
if necessary. The correct gap is 0.024˝ (0.6 mm).
The spark plug should be replaced after about 100
operation hours or earlier if the electrodes are badly
eroded.
0.024"
(0.6 mm)
NOTE
In some areas, local law requires using a resistor
spark plug to suppress ignition signals. If this
machine was originally equipped with resistor
spark plug, use same type of spark plug for
replacement.
Angle transmission (Fig. 25)
Check angle transmission or angle gear for
grease level about every 50 hours of operation by
removing the grease fi ller plug on the side of angle
transmission.
If no grease can be seen on the fl anks of the gears,
fi ll the transmission with quality lithium based
multipurpose grease up to 3/4. Do not completely fi ll
the transmission.
14
Fig. 24
Fig. 25
Semi-auto cutting head
Nylon line replacement
(1) Remove the case (22) by fi rmly pushing inward
the locking tabs with your thumbs as shown in
Fig. 26.
(2) After removing the case, take out the reel and
discard the remaining line.
(3) Fold the new nylon line unevenly in half as shown
in picture.
Hook the U-shaped end of the nylon line into the
groove (23) on the center partition of the reel.
Wind both halves of the line on the reel in the
same direction, keeping each half of the line on
its own side of the partition. (Fig. 27)
4˝ (10 cm)
(4) Push each line into the stopper holes (24),
leaving the loose ends approx. 4˝ (10 cm) in
length. (Fig. 28)
(5) Insert both loose ends of the line through the
cord guide (25) when placing the reel in the case.
(Fig. 29)
22
Fig. 26
23
Fig. 27
24
Fig. 28