Key Off Enable; Map Copy - Yamaha DTXPRESS III Manual De Instrucciones

6-8. Key Off Enable

This function decides whether or not to recognize key off mes-
sages for each drum voice w assigned to each MIDI note number
q.
UT MAP N= 0C -2
Key Off= disable
q N (MIDI Note Number)
Selects the MIDI note number (The same procedure as in [6-1.
Voice]).
w Key Off
enable: Recognizes key off.
disable: Does not recognize key off.
* When this is set to "disable", some voices may sound continu-
ously. Press the [SHIFT] and [VOICE] buttons to stop voices
sounding.
This function copies the preset drum map's entire internal settings
to a user drum map.
q
w
q from (Preset Drum Map)
Selects the preset drum kit number (1-48) that will be the copy
source. The drum kit number and drum kit name will be displayed.
Procedure
1. In the display shown above, assign the copy source drum
2. Press the [SAVE/ENT] or [VALUE+] button, the copy

6-9. Map Copy

UT MAP Copy From
= 1 Acoustic Kit
When the Map Copy function is used, the user drum
map's internal settings will be erased and replaced
with the settings of the copy source. If you want to
keep important user drum map settings, use the bulk
dump operation and save the settings to an external
device before executing the map copy.
kit (drum map), press the [SAVE/ENT] button.
The following display will appear asking for confirmation
before the copy operation is carried out.
Copy Map From
Are you sure ?
operation will be carried out.
* Press the [VALUE-] button to cancel the copy operation.
When the copy operation is complete, "Complete!" will
appear.
Utility Mode
q
1
39