Input Exchange; Trigger Setup Name - Yamaha DTXPRESS III Manual De Instrucciones

* Even when the drum kit is changed, the pads connected to the
assigned trigger input jacks will retain their increment/decre-
ment functions. To assign this function to each drum kit, refer to
the Drum Kit Voice Edit mode's [2-6. Function] (P. 21)

2-3. Input Exchange

Switches the trigger signal from the pads between trigger input
jacks 1 and 9/10.
TRIG Common
In Excg= normal
q In Excg (Input Exchange)
normal: Normal operation
9åß10:
Re-routes the signals of inputs 9 and 10 (9m10/10m9).
1åß9:
Re-routes the signals of inputs 1 and 9 (1m9/9m1).
Since the cymbal cup voice is usually assigned to Input jack 10
when a PCY10 is connected to Input jack 9/10, the 9åß10 setting
is recommended.
If a pad is added via the KP65's Input jack, connect the KP65 to
Input jack 9/10 and use the 1åß9 setting.
* You can connect the TP65S to Input jack 1, however the left rim,
when the clamp is positioned on the top, will produce no sound.
The main pad (center) and right rim section will produce sepa-
rate sounds.

2-4. Trigger Setup Name

Changes the name of the currently selected (currently being ed-
ited) Trigger Setup.
TRIG Common
TrgName=Medium
q TrgName (Trigger Setup Name)
Procedure
1. In the display shown above, use the [SEL<]/[SEL>] but-
tons to move the cursor to the character you want to
change.
2. Use the [VALUE–]/[VALUE+] buttons to select the alpha-
bet, number or symbol.
3. Repeat steps 1 and 2 above to create the Trigger Setup
name using a maximum of 8 characters.
The available characters to choose from are (in order):
space
!"#$%&'()*+,-./0123456789:;<=>?@
ABCDEFGHIJKLMNOPQRSTUVWXYZ[\]^_`
abcdefghijklmnopqrstuvwxyz{|}ßå
q
q
Trigger Setup Edit Mode
15