Dump Interval; Send Hi-Hat Control; Host Thru Port; Clk (Click) Group - Yamaha DTXPRESS III Manual De Instrucciones

Utility Mode

3-8. Dump Interval

This sets the length of intervals between the packets of MIDI data
sent by the DTXPRESS III Bulk Out function. The intervals can
be adjusted to the capacity of the external receiving MIDI device
to prevent data overflow.
UT MIDI SETUP
DumpInterval=100
q DumpInterval (Dump Interval)
[Range] 50, 100, 150, 200, 250, 300 (in msec.)

3-9. Send Hi-Hat Control

This sets whether or not hi-hat controller events will be transmit-
ted from the MIDI OUT jack or TO HOST jack.
UT MIDI SETUP
Send HH Ctrl= on
q Send HH Ctrl (Send Hi-Hat Control)
on: Sends data to the MIDI OUT jack and TO HOST jack.
off: Does not send data to the MIDI OUT jack and TO HOST
jack.
* This setting does not affect internal operating data for the hi-hat
controller.

3-10. Host Thru Port

This enables the DTXPRESS III to transmit multi-port type mes-
sages received from the TO HOST jack. Only messages corre-
sponding to the set port number will be sent via MIDI.
* This setting only has affect when the TO HOST switch is set to
a position other than "MIDI".
UT MIDI SETUP

Host Thru Port=1

q Host Thru Port
Assigns the Port Number (1-8).
34
Contains various settings for the DTXPRESS III's Click Voice
functions.
This group is divided into the following 6 pages.
q
Click voice sets each contain three preset voices that are used for
the click sound and selected as a group. When "User Voice" is
selected, the following pages can be used to create a custom click
voice set.
q
q Click Voice Set
Select the Click Voice Set you would like to use.
Metronome
Vocal
This function sets each of the 3 click voices used for the click
sound. Drum voices are assigned.
q
q Click (Click Voice)
Select and set the Click Voice for the click sound.
hi: Used for the click at the beginning of the measure.
mid: Used for quarter note beats.
lo: Used for other clicks for notes of smaller quantization.
w Voice Category
Sets the voice to be used for the Click Voice selected in step q
Click, select a drum voice category.
Refer to Drum Kit Voice Edit Mode's [1-1. Voice] (P. 18).
e Voice Number Voice Name
Selects the voice that will be assigned. The Voice Number (1-127)
and Voice Name will be displayed.

4. CLK (Click) Group

4-1. Click Voice Set ................................................. 34

4-2. Click Voice ....................................................... 34

4-3. Click Volume, Tuning ........................................ 35

4-4. Click Note Number .......................................... 35

4-5. Click Mode ....................................................... 35
4-6. Click Out Select ............................................... 35

4-1. Click Voice Set

UT CLK VOICESET
=Metronome
Wood Block Percussion
, ,
User Voice
,

4-2. Click Voice

UT CLK Click= hi
=P/053 MtBel
w e
[Range] K, k, S, s, T, t, C, H, P, E, e, L, m
[Range] 0, 1-127
q
Agogo Stick
, , ,
q