Sony VPL-CX86 Manual De Referencia página 24

Symptom
The picture flickers.
Indicators
Indicators
POWER SAVING
TEMP/FAN
LAMP/COVER
I/1 indicator
12
Troubleshooting
Cause and Remedy
"Dot Phase" on the INPUT SETTING menu has not been adjusted
properly.
c Adjust "Dot Phase" on the INPUT SETTING menu properly.
Status and Remedy
Lights up when the projector is in power saving mode.
Lights up when temperature inside the projector becomes unusually
high. Check to see if anything is blocking the ventilation holes.
Flashes when the fan is broken. Consult with qualified Sony
personnel.
Lights up when the lamp has reached the end of its life or becomes a
high temperature. Wait to cool down the lamp and turn on the power
again, or replace the lamp.
If it lights after you replaced the lamp, the electrical system may
have broken down. Consult with the qualified Sony personnel.
Flashes when the lamp cover is not secured firmly. Attach the cover
securely.
Lights in red in standby mode. You can turn on the projector with
the ?/1 key.
Lights in green when the power is turned on.
Flashes in green from the projector is turned on until the projector is
ready to operate. Also, flashes in green while the cooling fan runs
after the power is turned off with the ?/1 key. During this time, you
will not be able to turn on the projector.