EGO ST1500E Manual Del Usuario página 14

Wind the spool with new line
EN
WARNING:
To prevent serious personal injury, remove the battery pack from the
tool before servicing, cleaning, changing attachments or removing material from the unit.
1. Press the release tabs on the spool
base and remove the spool retainer
by pulling it straight out (Fig. 18).
2. Remove the spool. Use a clean cloth
to clean the inner surface of the
spool retainer and spool base.
NOTICE: Always clean the spool retainer,
spool and spool base before reassembling
the trimmer head.
3. Check the spool retainer, spool and
spool base for wear. If necessary,
replace the worn parts.
4. Take approximately 6m of new
cutting line. Fold the line in half
and then adjust it so that one end
is 11cm longer than the other end
(Fig. 19).
5. Hook the folded end of the cutting
line onto either of the slots in the
spool (Fig. 20).
6. Wind the line, in two even and tight
layers, onto the spool. Wind the line
in the direction indicated on the
spool (Fig. 20).
26
56 VOLT LITHIUM-ION CORDLESS BRUSHLESS STRING TRIMMER — ST1500E
18
Tab
19
11 cm
20
Wind Direction
NOTICE: Failure to wind the line in the direction indicated will cause the trimmer head
to operate incorrectly.
7. Place the ends of the line in two
opposite notches in the spool, with
approximately 15 cm protruding
(Fig. 21).
8. Align the notches of the spool from
which the lines protrude with the
eyelets in the spool retainer and
position the spool in the retainer
(Fig. 22).
56 VOLT LITHIUM-ION CORDLESS BRUSHLESS STRING TRIMMER — ST1500E
21
15 cm
22
Notch
Notch
Eyelet
Eyelet
27
EN