Maintenance - EGO ST1500E Manual Del Usuario

9. Holding the spool and spool retainer, grasp one end of the line and pull it to
EN
release the line from the notch in the eyelet. Repeat with the other end (Fig. 23).
23
10. With the spool base facing
downward, align the slots in the
spool retainer with the tabs on the
spool base and press the retainer
evenly down until it snaps into place
(Fig.24).
NOTICE: Make sure that the tabs on the
spool base snap into place or the spool
will come out during operation.
Install a pre-wound spool
WARNING:
To prevent serious personal injury, remove the battery pack from the
tool before servicing, cleaning, changing attachments or removing material from the unit.
1. Press the release tabs on the spool base and remove the retainer by pulling it
straight out (Fig. 18).
2. Remove the spool. Use a clean cloth to clean the inner surface of the spool
retainer and spool base.
3. Check the spool retainer, spool and spool base for wear. If necessary, replace the
wear parts.
4. Place a pre-wound spool on the spool retainer.
28
56 VOLT LITHIUM-ION CORDLESS BRUSHLESS STRING TRIMMER — ST1500E
24
Tab
Slot
5. Align the notches of the spool from which the lines protrude with the eyelets in
the spool retainer and position the spool in the retainer (Fig. 22).
6. Holding the spool and spool retainer, grasp one end of the line and pull it to
release the line from the notch in the eyelet. Repeat with the other end (Fig. 23).
7. With the spool base facing downward, align the slots in the spool retainer with
the tabs on the spool base and press the retainer evenly down until it snaps into
place (Fig. 24).
NOTICE: Make sure that the tabs on the spool base snap into place or the spool will
come out during operation.

MAINTENANCE

WARNING:
When servicing, use only identical replacement parts. Use of any
other parts may create a hazard or cause product damage. Inspect and maintain the
machine regularly. To ensure safety and reliability, all repairs should be performed by a
qualified service technician.
WARNING:
Battery tools do not have to be plugged into an electrical outlet;
therefore, they are always in operating condition. To prevent serious personal injury,
take extra precautions and care when performing maintenance, service or for changing
the cutting attachment or other attachments.
WARNING:
To prevent serious personal injury, remove the battery pack from
the tool before servicing, cleaning, changing add-on attachments or removing material
from the unit.
CLEANING THE UNIT
◾ ◾
Clean the unit using a damp cloth with a mild detergent.
◾ ◾
Do not use any strong detergents on the plastic housing or the handle. They can
be damaged by certain aromatic oils, such as pine and lemon, and by solvents
such as kerosene. Moisture can also cause a shock hazard. Wipe off any moisture
with a soft dry cloth.
◾ ◾
Use a small brush or the air discharge of a small vacuum cleaner brush to clean
the air vents on the shaft.
◾ ◾
Keep the air vents free of obstructions.
56 VOLT LITHIUM-ION CORDLESS BRUSHLESS STRING TRIMMER — ST1500E
EN
29