Hairdryer - VALERA 530 Serie Modo De Empleo

• Do not try to recover an electric appliance fallen into water, but
unplug it immediately from the mains supply.
• Turn the unit off when you put it down.
• Unplug the appliance when not in use, but never do it by pulling the
cord.
• Remember to check regularly that the air inlet and outlet grills are clean.
• Allow your appliance to cool before storing away and do not wrap
the supply cord around the hairdryer in storage.
• This unit must only be used for the purposes for which it is
expressly intended. Any other use is to be considered improper
and therefore dangerous. The manufacturer accepts no
responsibility for damage caused by improperor erroneous use.
• (Only for models 560.., 566.., 581.., 583.., 584..,585.., 586..)
This hairdryer is designed for professional use.
When set to maximum temperature values, the appliance produces
very hot air. To avoid damaging the hair or skin when using the
product in a domestic environment, select lower temperature
values or do not concentrate on individual areas for too long.
• The A-weighted sound pressure level of the hairdryers for
professional use is below 70 dB(A).
• Designation of the appliance (see technical product specifications)
HAND-HELD HAIR DRYER FOR PROFESSIONAL USE
Important
This hairdryer conforms to the safety regulations regarding
electrical appliances.
This hairdryer has a safety cut-out which will operate in case
of overheating. The dryer will re-set itself after being left to
cool for a few minutes, but please check air inlet and outlet
grills are perfectly clean before continuing to use the dryer.
This appliance conforms to European Directives 2014/30/EU,
2014/35/EU, 2011/65/EC, 2009/125/EC, and Regulation (EC)
No. 1275/2008.
OPERATING INSTRUCTIONS
Switching (only if applicable to the model purchased)
Model 530.., 533.., 541.., 542.., 553.., 554..
ON=ON/OFF Pressure must be maintained to operate the

hairdryer)

0=Off
COOL=tepid air
1=warm/low power
2=hot/high power
Model 543., 545., 560., 561., 566., 581., 583., 584., 585.,586..
Fan Setting
0=Off 1=tiepid air (=COOL model 543.., 545.., 561..)
1=low power 2=warm (=1/ECO model 543.., 545.., 561..)
2=high power 3=hot (=2/MAX model 543.., 545.., 561..)
Mod. 583.11/P , 583.10, 584.02/IP , 584.03/P ., 585.., 586..
ON=On/Off (pressure must be maintained to operate
the hairdryer)
Fan Setting
0=Off 1=tiepid air
1=low power 2=warm
2=high power 3=hot
COOL or COLD function
(for hairdryers fitted with this device) - Fig. 2
This function is used to set hair waves after styling.
Styling nozzle
Fit the flat-air styling nozzle onto the hairdryer for added styling
control whilst drying.
5
Temperature setting
Temperature setting