Makita BFS440 Manual De Instrucciones página 6

Depth adjustment
1
A
B
008878
The depth can be adjusted by turning the locator. Turn it
in "B" direction for less depth and in "A" direction for more
depth. One full turn of the locator equals 1.5 mm
(1/16")change in depth.
Adjust the locator so that the distance between the tip of
the locator and the screw head is approximately 1 mm
(0.04") as shown in the figures. Drive a trial screw into
your material or a piece of duplicate material. If the depth
is still not suitable for the screw, continue adjusting until
you obtain the proper depth setting.
1mm (0.04")
1
008879
1mm (0.04")
1
008881
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.
Installing or removing the bit
To remove the bit, pull the locator. Then grasp the bit with
a pair of pliers and pull the bit out of the magnetic bit
holder. Sometimes, it helps to wiggle the bit with the
pliers as you pull.
1. Locator
1. Locator
1. Locator
6
1
008883
To install the bit, push it firmly into the magnetic bit holder.
Then install the locator by pushing it firmly back.
2
1
3
008891
Bit storage
008890
Fit the bit into the protrusion at the tool.
Carry hook
The carry hook is convenient for temporarily hooking the
tool. It can be installed on either side of the tool.
When removing the carry hook, widen it by pressing its
right ends ON BOTH SIDES in the directions of arrow (1)
and raise it in the direction of the arrow (2).
1
2
1
1
008884
1. Locator
1. Locator
2. Bit
3. Magnetic bit
holder
1. Hook