Flex FX1371A Manual Del Operador página 10

REMOVABLE BIT CLIP (FIG.4)
Your tool is also equipped with a removable bit
clip that can be positioned on the side of the
tool for storing bits.
Install the bit clip onto the tool:
a. Remove the battery pack from the tool.
b. Align the hole of the bit clip with the threaded
hole on the base of the tool.
NOTICE: Ensure that the protruding part on the
bit clip is kept flush against the step on the base
of the tool to keep it steady.
c. Insert the screw and securely tighten the
screw with a screwdriver (not included).
Remove the bit clip from the tool:
a. Remove the battery pack from the tool.
b. Use a screwdriver to loosen the screw that
attaches the bit clip to the impact wrench.
c. Remove the screw and the bit clip.
INSTALL AND REMOVE BITS (FIG. 5)
Your tool is equipped with a quick-change chuck,
making bit installation and removal very easy.
Lock the variable-speed trigger switch "OFF" by
placing the direction-of-rotation selector in the
center position.
To install the bit (not included):
Depress the accessory install/release button;
the locking sleeve will move forward (away from
the tool)Insert the bit as far as it will go into the
chuck, and then release the accessory install/
release button to lock the bit in place.
To remove the bit:
Depress the accessory install/release button to
push the locking sleeve forward (away from the
tool). Pull the bit from the chuck and release
the accessory install/release button, the locking
sleeve will retract to original position.
NOTICE: Use only bits with power grooves;
other bits can be used with a universal bit
holder that has power groove (not included). Do
not use a bit that has a damaged shank.
Fig. 4
Removable Bit Clip
Fig. 5
Accessory Install / Release Button
WARNING
from the tool, or first allow the bit to cool
down. The bit may be hot after prolonged
use.
-10-
Step
Protuding
Part
Use protective gloves
when removing the bit