VOX electronics МC-9005 Manual De Usuario página 8

Disassemble method: Take out the side blade unit by clockwise from the main blade unit.
Remark
1. There are 2 anti –slip lines on the main/side blade unit. If the 2 lines didn't align well it means the
main/side blade unit is not well assembled.
2. If you didn't assemble the side blade well before using, the side blade unit may loose and touch the
bowl or lid and hurt the human. Please use it correctly.
3. There is a safety lock on the main unit. During operation, please lay the appliance flat and press the
button strongly to start operating, otherwise the appliance cannot be activated.
4. Meat food making method: can choose only single layer or double layers blades for your mini
chopper. Install the blade into chopping bowl, remove the muscle, bone, skin of the meat food be-
fore processing, cut the food into 1-2 cm size and put into the bowl. The processing food cannot ex-
ceed the maximum limit of the scale line of corresponding meat food.
Fruits and vegetables making method: choose double layers blade, install the main or side blade
into bowl, cut the food into strips wide about 1-2 cm, length should not be more than 5-10 cm. The
massive food should not more than 2-3 cm. The processing food cannot exceed four-fifths of
the total bowl, make the lid exactly match the edge of the bowl.
5. Connect the power supply, press the switch lightly, start working. Do not run the appliance for more
than 30 seconds continuously
6. This appliance has 2 levels.
7. After processing, unplug the device. After the blade has stopped running, move out the main unit
and open the lid, remove the chopping blade, and take out the food with a spatula or chopsticks.
8. If the processing food sticks on the bowl, please turn off the switch and unplug the device, use a
spatula or chopsticks to scrape it off and then make the processing again.
9. If within 30 seconds the effect you want is not achieved, please loosen the switch and after interval of
2 minutes process aagain, which is conducive to extend the product life.
6