Descargar Imprimir esta página

Makita DLS211 Manual De Instrucciones página 32

Ocultar thumbs Ver también para DLS211:

Publicidad

Idiomas disponibles

Idiomas disponibles

5.
Install both the upper fences on the tool.
WARNING:
Do not use the tool without upper
fences installed. The upper fences provide the ade-
quate support required to cut the workpiece.
If the workpiece is not supported properly, it may
move resulting in possible loss of control, kickback
and serious personal injury.
6.
Place the workpiece to be cut on the platform
secured to the tool.
7.
Secure the workpiece firmly against the upper
fences with a vise before cutting.
1
► 1. Upper fence 2. Vertical vise 3. Workpiece
4. Platform
8.
Make a cut through the workpiece slowly accord-
ing to the operation explained in the section for slide
(push) cutting.
WARNING:
Ensure that the workpiece is
secured with the vise and make the cut slowly.
Failure to do so may cause the workpiece to move
resulting in possible kickback and serious personal
injury.
WARNING:
Be aware that the platform may
become weakened after several cuts are per-
formed at various miter angles. If the platform
becomes weakened due to the multiple kerf cuts left
in the material, the platform should be replaced. If the
weakened platform is not replaced, it may cause the
workpiece to move, during cutting, resulting in possi-
ble kickback and serious personal injury.
Groove cutting
WARNING:
Do not attempt to perform this
type of cut by using a wider type blade or dado
blade. Attempting to make a groove cut with a wider
blade or dado blade could lead to unexpected cutting
results and kickback which may result in serious
personal injury.
WARNING:
Be sure to return the stopper arm
to the original position when performing other
than groove cutting. Attempting to make cuts with
the stopper arm in the incorrect position could lead to
unexpected cutting results and kickback which may
result in serious personal injury.
For a dado type cut, perform as follows:
1.
Adjust the lower limit position of the saw blade
using the adjusting screw and the stopper arm to limit
the cutting depth of the saw blade. Refer to the section
for stopper arm.
2.
After adjusting the lower limit position of the saw
blade, cut parallel grooves across the width of the work-
piece using a slide (push) cut.
2
3
4
► 1. Cut grooves with blade
3.
Remove the workpiece material between the
grooves with a chisel.
Wood facing
WARNING:
facing to the guide fence. The screws should be
installed so that the screw heads are below the
surface of the wood facing so that they will not
interfere with the positioning of the material being
cut. Misalignment of the material being cut can case
unexpected movement during the cutting operation
which may result in a loss of control and serious
personal injury.
CAUTION:
ness for the wood facing.
CAUTION:
workpieces with a height of 107 mm to 120 mm
(4-1/4" to 4-3/4"), a wood facing should be used
on the guide fence. The wood facing will space the
workpiece away from the fence allowing the blade to
complete a deeper cut.
NOTICE:
not turn the turn base with the handle lowered.
The blade and/or the wood facing will be damaged.
32 ENGLISH
1
Use screws to attach the wood
Use straight wood of even thick-
In order to completely cut through
When the wood facing is attached, do

Publicidad

loading

Este manual también es adecuado para:

Dls212