SEA VERG 24V L Manual Del Usuario página 6

Sistemi Elettronici
di Apertura Porte e Cancelli
International registered trademark n. 804888
6) Mounting of the oval beam
Note: For 4 and 5 m beams it is recommended to use the fork support or the flexible support.
Joint
Led profile
(B)
Fig. 9-a
Mount the first segment (A) of the LED profile, positioning it in doorstop on the fixing, mount the joint, fit the second
segment (B) of the LED profile and repeat the operation for all segments of the LED profile up to covering the length of
the whole beam. The last profile LED must be cut with a hacksaw at the end of the rod (Fig.9-a). Intersperse each
segment of the LED profile with a joint.
Mount the anti-blunt rubber so that it comes out from the beam about 5mm (Fig.9-a).
®
Led profile
(A)
Anti-blunt rubber
Fixing
English
Fig.9
15