Dyna-Glo DGE486BSP Manual De Instrucciones página 18

ASSEMBLY INSTRUCTIONS
18. Open the cart door assembly (J&K), insert
hose/regulator assembly into the cart
assembly through the hole on cart left side
panel (H). Pull the tank shelf (G) out of the
cart, place gas cylinder (sold separately) onto
tank shelf (G). Rotate the gas cylinder until the
hose/regulator coupling can easily be attached
to the valve on the LP cylinder. Hand-tighten
the hose/regulator coupling to the threaded
valve of the LP gas cylinder. Tighten gas cylinder
retaining bolt. Slide tank shelf (G) back into cart
and secure in place by swinging the tank shelf
rail locking plate over and in front of the tank
shelf (G).
Fully Assembled
Front View
Rear View
18
J
18
G
G
Tank shelf rail
locking plate
K