Cup Holder - BABYTREND ST28C22B Manual De Instrucciones

ASSEMBLY
REMOVABLE BUMPER BAR
WARNING:
use bumper bar to carry seat
with child inside. The bumper
bar is not a carrying handle.
5) • Attach the bumper bar by lining up
anchors with the slots on the seat. Push
until it clicks into place (Fig. 5a).
NOTE: The bumper bar must be securely
attached before using this product.
• To access the child seat, press the
release button and pull bar out of the
anchor. Swing the bar upwards to access
the seat (Fig. 5b). Press both buttons
simultaneously and pull out to remove the
bumper bar (Fig. 5c).
SEATBACK POSITIONING
6 • To put seat into the upright position, press
the clip ends together, hold the hoop to
push the clip up and buckle the top straps
(Fig 6a).NOTE: The upright position
should be used only for a child that is
at least 6 months old. Always re-adjust
the safety harness, including the shoulder
belts when repositioning the seatback.
5
Copyright © 2018, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
Do not
Fig. 5a
Fig. 5b
Fig. 5c
Fig. 6a
• To recline the seat, release the buckle,
press the clip ends together and pull it
down (Fig 6b).
ADJUSTING THE LEG SUPPORT
7) • Lift to raise the leg support. Press the
buttons on both sides of the leg support
to lower (Fig. 7).

CUP HOLDER

WARNING:
To avoid
burns, never put hot liquids
in cup holder. Avoid possible
tipping, do not place more
than 1 lb. (0.45kg) in cup
holder.
8) • To attach cup holder: slide the clip on the
cupholder over Cup Holder tabs on the
Handle Bar. Push untill firmly in place
(Fig. 8).
Copyright © 2018, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
ASSEMBLY
Fig. 6b
Fig. 7
Fig. 8
6