Mounting An Abrasive Cutting Wheel - Stihl TS 440 Manual De Instrucciones

English
Using the electronic water control
Start the engine: see the chapter
N
"Starting/Stopping the Engine."
Briefly push the (+) button or ( )
N
button with the thumb of the right
hand. To avoid loss of control, the
right hand must always remain on
the rear handle while doing so; the
left hand must always remain on the
front handle. No water is fed to the
cutting wheel during idling.
During use, the amount of water set by
the operator is delivered to the cutting
wheel.
Adjust the water flow as necessary
N
to do so, repeatedly push the (+)
button or ( ) button with the thumb
of the right hand until the correct
water quantity is attained. To avoid
loss of control and the possibility of
severe personal injury or death, the
right hand must always remain on
the rear handle while doing so; the
left hand must always remain on the
front handle.
The water pressure of the source water
supply will affect the actual amount of
water flow to the cutting wheel at any
setting. For proper dust suppression and
cutting performance, always make sure
that the water flow is within the proper
range, as described in the chapter
"Sample Applications."
If the cut-off machine is idling after use,
water will not be fed to the cutting wheel
the electronic water control, however,
remains activated. When use is
resumed, the last water volume setting
will be automatically resumed.
34
If the engine is stopped, the electronic
water control is turned off. Upon re-
starting, the electronic water control
must be reset to the appropriate water
flow.
Maintenance and care
If too little water or no water is fed to the
cutting wheel during use even though
the electronic water control has been
activated and adjusted:
1 2
Remove the coupling sleeve (1)
N
Unscrew the "water connection with
N
screen" (2) and rinse it under
running water the screen remains
on the water connection
If the electronic water control still is
N
not adjusting water flow properly,
the machine should be taken to an
authorized STIHL dealer for service
Mounting an Abrasive
Cutting Wheel
The engine must be shut off for
mounting or replacing a wheel
slide control to STOP or 0.
Blocking the shaft
2
1
Slide the locking pin (1) through the
N
bore hole (2) in the V - belt guard
Pull the break lever toward the front
N
handle and hold it
Turn the shaft with the combination
N
wrench until the locking pin (1)
engages in the bore hole behind the
guard
Release the brake lever
N
set the
TS 440