Sony SPP-SS960 Manual De Instrucciones página 13

Step 4
Entering your area code
When you use this phone for the first time, or move to an area that has
a different area code, you must enter your area code.
This is necessary because the phone must distinguish local or long
distance calls to properly dial calls from the Caller ID list.
Turn Press
Notes
• If an area code is already entered, it appears on the display in step 3. To enter
a different area code, see "To change the area code" below.
• Do not allow more than 20 seconds to elapse between each step of the
procedure.
Tips
• You may press Jog Dial instead of (PGM/VOL) in step 5.
• To check the current area code, perform steps 1 to 3 above. The area code
appears on the display for 20 seconds.
To change the area code
1
Perform steps 1 to 3 above.
The current area code appears on the display.
2
Turn Jog Dial down to erase the current area code.
3
Enter a new area code using the dialing keys.
4
Press (PGM/VOL).
You hear a long confirmation beep.
1
Press (PGM/VOL).
2
Turn Jog Dial up to make "AREA"
flash.
DIRECTORY AREA
3
Press Jog Dial.
"ENTER AREA CODE" appears on
the display.
4
Enter three digits of your area code
using the dialing keys.
5
Press (PGM/VOL).
You hear a long confirmation beep.
EN
13
Getting Started