Bosch DIK106750 Instrucciones Para El Uso página 16

Filters and maintenance
Inserting the filter:
Warning: The halogen bulbs must be
switched off and cool.
1. Remove the metal filters
(see "Removing and inserting the metal
grease filters").
2. . . Insert the activated carbon filter. Fig. 2.
3. Raise the activated carbon filter in front
and rotate the closures by 90°. Fig. 3.
4. Insert the metal grease filters
(see Removing and inserting the metal
grease filters).
5. Cancel the C in the display.
Switch the motor off (stop position).
Press for some seconds at the same
time 0 and T push buttons. A signal
sounds on the display and the display
symbol ~ at the side goes out.
Removing the filter:
Warning: The halogen bulbs must be
switched off and cool.
1. Remove the metal filters.
2. Rotate the closures by 90° and remove
the activated carbon filter downwards.
Fig. 3.
3. Insert the metal grease filters.
Replacing the activated carbon filter:
During normal operation (1 to 2 hours
per day) the activated carbon filters
should be replaced approximately 1 x
year.
A replacement filter can be obtained
from any authorized dealer.
Use original filters only.
By doing so you will obtain maximum
performance from your extractor hood.
Disposing of the old activated carbon
filter:
There are no pollutants in the activated
carbon filters. They can therefore be
disposed of as part of your normal
domestic refuse.
16
The electronic controls allow automatic
control of the fat filters and the carbon filters
(only when the hood is used in filtering
version), so that the user does not have to
remember when maintenance was last
carried out.
When the metallic fat filters have to be
cleaned, then F on the display will flash.
When the carbon filters have to be
replaced, C on the display will flash.
It is possible to interrogate the
electronic system concerning how clean the
fat filters are and how worn the carbon
filters are, as follows: stop the motor and ...
... To find out how clean the fat filters are,
press the 0 and – buttons at the same time.
On the display, a number between 0 and 9
will appear, the smaller the number, the
dirtier the filter is and vice versa.
... To find out how worn the carbon filters
are, press the 0 and + button at the same
time. On the display a number between 0
and 9 will appear, the smaller the number,
the more worn the filter and vice versa.