dirna Bergstrom bycool COMPACT 1.4 Instrucciones De Montaje página 31

COMPACT 1.4
EN
®
Take the power cable from the unit through to the vehicle's current breaker (positive) and
1
grounding (negative), attaching the plastic supports to the rear of the cabin and securing with
flanges; then, with the cabin tilted, pass the cable through the bottom, securing it with clamps
and M4 screws; and through to the battery with flanges; use the same passage as the original
cabling (inside the exhaust pipe protection (A)). (Clean the area thoroughly before attaching
the plastic supports). When the unit is connected to the battery, this will carry out a test of all
the LEDs, displaying 88-bd and then going off.
! IMPORTANT: Check the User Manual before starting up.
31