Accessing The Unit; Opening The Container; Hinging The Screen Holder Up/Down; Installation And Connection - Oase BioTec ScreenMatic2 40000 Instrucciones De Uso

- EN -
• Do not use for commercial or industrial purposes.
• Not suitable for salt water.
• Do not use in conjunction with chemicals, foodstuff, easily flammable or explosive substances.
3.5

Accessing the unit

• Remove the container cover: Access to the control device.
• Hinge up the screen holder: Access to the foam filters, substrate tubes, separating plate and outlet.
3.5.1

Opening the container

 E
• BioTec ScreenMatic² 40000/60000: Release the locking clips, lift up the cover and remove.
• BioTec ScreenMatic² 140000: Lift the cover using the handles and remove.
– Screw the handles onto the cover. The handles are not fitted on delivery.
N O T E
Only operate the unit with the container cover in place.
3.5.2

Hinging the screen holder up/down

How to proceed:
 F
To hinge up/open
1. Remove the debris tray.
2. Hinge up the distributor extension.
3. Hinge up the screen holder with the ScreenMatic rotating screen unit.
To hinge down/close
4. Carefully hinge down the screen holder.
5. Push the distribution extension down until it audibly engages.
6. Replace the debris tray.
4

Installation and connection

4.1

Installation planning

 G
W A R N I N G
Dangerous electrical voltage.
Possible consequences: Death or severe injuries caused by electric shock from electrical units oper-
ated in or near water.
Protective measures for accessible ponds:
• Only use electrical units or installations with a rated voltage of U
ter.
• Electrical installations with a rated voltage of U
tance of at least 2 m from the water.
Protective measures for non-accessible ponds:
• Electrical installations with a rated voltage of U
tance of at least 2 m from the water.
N O T E
Use suitable transport and lifting aids to transport and install the unit.
The unit weighs more than 25 kg. (→ Technical data)
32
≤ 12 V or U
AC
> 12 V or U > 30 V must be located at a dis-
AC DC
> 12 V or U > 30 V must be located at a dis-
AC DC
≤ 30 V in the wa-
DC