Operation; Operating Panel; Manual Cleaning - Oase BioTec ScreenMatic2 40000 Instrucciones De Uso

- EN -
• Align the control device such that the sensor only switches when a well-formed line of debris has formed on
the screen.
– A well-formed line of debris can be optimally removed by the stripper and conveyed into the debris tray.
– The stripper brush under the ScreenMatic screen collects the fine debris, which falls into the debris tray.
How to proceed:
 L
1. Remove the screw from the control device and take out the control device.
2. Insert the control device into the determined position, insert the screw and hand tighten.
Aligning the control device depending on the degree of soiling of the pond
In order to prevent premature soiling of the foam filters, ensure that the dirty water does not flow beyond the
"Max. water jet" mark directly into the debris tray.
• Do not change the position of the control device unless the water flows as far as or beyond the "Max. water
jet" mark, even when the ScreenMatic screen has been cleaned (with the enclosed brush).
(→ Cleaning/replacing the ScreenMatic screen)
Typical position of the control device
BioTec ScreenMatic² 40000
<6000 l/h
>8000 l/h
Delivery state
6

Operation

6.1

Operating panel

1 LED, 2 colours
• Lit green
• Flashes green
• Flashes green/red
• Flashes red
2 Button, start/stop manual cleaning
6.2

Manual cleaning

Proceed as follows
Press for 1 s.
36
BioTec ScreenMatic² 60000
<7 <8000 l/h
>7 >9000 l/h
7 Delivery state
Description
The ScreenMatic screen is rotated by 1 revolution.
• Press the button again for 1 s: The rotational movement stops prematurely.
BioTec ScreenMatic² 90000
<9 <9000 l/h
>9 >11000 l/h
9 Delivery state
The ScreenMatic rotating screen unit is operational
Cleaning active
Malfunction (→ System messages)
Malfunction (→ System messages)
(→ Manual cleaning)
BioTec ScreenMatic² 140000
<10 <12000 l/h
>10 >15000 l/h
10 Delivery state
<18
>18
18
BTC0046