Makita LS1018 Manual De Instrucciones página 10

1 2 4
3
001786
To install the blade, mount it carefully onto the spindle,
making sure that the direction of the arrow on the
surface of the blade matches the direction of the arrow
on the blade case.
Install the outer flange and hex bolt, and then use the
socket wrench to tighten the hex bolt (left-handed)
securely counterclockwise while pressing the shaft lock.
1
010562
Return the blade guard and center cover to its original
position. Then tighten the hex bolt clockwise to secure
the center cover. Release the handle from the raised
position by pulling the stopper pin. Lower the handle to
make sure that the blade guard moves properly. Make
sure the shaft lock has released spindle before making
cut.
Dust bag (accessory)
1
2
3
011339
The use of the dust bag makes cutting operations
cleaner and dust collection easier. To attach the dust
bag, fit it onto the dust nozzle.
When the dust bag is about half full, remove the dust
bag from the tool and pull the fastener out. Empty the
dust bag of its contents, tapping it lightly so as to
remove particles adhering to the insides which might
hamper further collection.
1. Hex bolt
5
2. Outer flange
3. Saw blade
4. Inner flange
5. Spindle
1. Socket wrench
2
2. Blade case
3. Center cover
3
4. Hex bolt
5. Blade guard
5
4
1. Dust nozzle
2. Dust bag
3. Fastener
NOTE:
If you connect a vacuum cleaner to your saw, cleaner
operations can be performed.
Securing workpiece
WARNING:
It is extremely important to always secure the
•
workpiece correctly with the proper type of
vise or crown molding stoppers. Failure to do
so may result in serious personal injury and cause
damage to the tool and/or the workpiece.
After a cutting operation do not raise the blade
•
until it has come to a complete stop. The
raising of a coasting blade may result in serious
personal injury and damage to the workpiece.
When cutting a workpiece that is longer than
•
the support base of the saw, the material should
be supported the entire length beyond the
support base and at the same height to keep the
material level. Proper workpiece support will help
avoid blade pinch and possible kickback which may
result in serious personal injury. Do not rely solely
on the vertical vise and/or horizontal vise to secure
the workpiece. Thin material tends to sag. Support
workpiece over its entire length to avoid blade pinch
and possible KICKBACK.
1
001549
Guide fence (SLIDING FENCES) adjustment
010480
CAUTION:
Before operating the tool, make sure that the
•
sliding fence is secured firmly.
Before bevel-cutting, make sure that no part of the
•
tool contacts the sliding fence when fully lowering
and raising the handle in any position and while
moving the carriage through its full range of travel.
10
1. Support
2
2. Turn base
1. Sliding fence
1
2. Clamping screw
2